SD> Door Glass

[Larry Carlson]

    My Haynes manual says I can remove the "belt moulding" (trim piece at the bottom of the window) from the door, once I roll down the window.  When I roll the window down, I can access the front two screws that hold the belt molding in place, but not the back three.  What's the trick here?  I'm thinking I have to remove the front and rear "run channels", then pull the glass off the regulator...

    ... which brings us to my next question;  How do I get the "sliders" (plastic gizmoes that guide the window in the "run channel") out of the run channel (metal tracks that the glass "runs" in)?  Haynes says to use special tool C-4867 from Miller Tool Co.  Miller Tool Co. says it is no longer available.  Can I use a plastic spatula (Bondo spreader) to pry them out?

    Thanks.

    Larry